![]() ![]() ![]() Reporting the presence of WiFi networks and local access points and the signal strengths of their beacons.Trouble-shooting an existing network or wireless environment that is performing poorly.During the installation of a wireless network, as an aid in verifying the network is properly configured and antennas are positioned at locations to achieve efficient transmission / reception - that is, for use in verifying WiFi coverage and maximizing beacon signal strength.After restart, your device is now connected wirelessly and ready for use. You may be prompted to reboot, please do so.Ħ. Click Finish to complete the installation. The On-Line registration prompt will appear, you may register now or at a later time. You will be prompted to view the User Guide, if you desire, please do so, then click Next.Ĥ. Note: Installation will continue, it may take several minutes, please allow it to finish. Your device will appear, highlight it and click Next. Note: If you get a connection failed message, run the setup again and make sure you have entered the correct password.Ģ. Please choose the network you wish to connect to - Click OK.Ĭhoose No (Manual) when prompted in regards to using AOSS. On the device, choose Settings, or Tools icon.Ĭhoose Setup Wizard - It will search all available SSID. You will have to use the wireless setup wizard on the device to connect it to your wireless network before it will be detected in the next step. Click the radio button No, I do not have a USB cable. If you haven't yet registered your product, it is recommended that you click on Brother Registration to register your product before complete the installation.ġ. Please DO NOT click Cancel or disconnect the USB cable. Note : It may take a few minutes to install the driver and search for the network router. Note: If you do not have a USB cable and would like to use the advanced setup, please click HERE. Please use Windows Explorer (or double click on My Computer or Computer icon) to go to this path =>Ĭ:\Users\\Downloads\install\data\Disk1 and then double click on Setup.exe. * Note : If you are getting this error message Cannot Start Application Installer. D ouble click on the downloaded file, click Run button and then proceed with the Software and Driver's installation by following the graphical (red box) steps below: After the driver downloaded to your Downloads folder, go to the Downloads folder.Ħ. ![]() D ouble click on the downloaded file, click Run button and then proceed with the Software and Driver's installation by following the graphical (red box) steps below:ĥ. After the driver downloaded to your PC's desktop, go to the Desktopĥ. At the left side of the Save dialog box, click on the Desktop icon and then click Save.ģ. ![]() If you have any applications are currently OPEN, please save and close your document(s) and then perform the following steps:Ģ. It is recommended that you setup the Wireless Scanner through the computer (PC) that connects wirelessly to your wireless network router. If you do not have this information, please contact your system administrator or router manufacturer for further support. IMPORTANT : You MUST know the Network Name (SSID) and Network key (Security/Encryption key) in order to proceed with the wireless installation. ![]()
0 Comments
Leave a Reply. |